NovaLink WM

Need More Information?

Contact Us
NovaLink™ WM is a cold applied, single component, waterproofing membrane that cures by exposure to atmospheric and substrate moisture to form a continuous, tough, reinforced elastic seal. NovaLink WM is solvent free and compliant with all known environmental and OSHA requirements. It can be used in confined spaces with standard personal protection equipment. NovaLink WM cures to an elastomeric rubber that is resistant to thermal shock. It will not crack in extreme cold or slump due to softening and high temperatures like conventional asphalt or coal tar based coatings often will.

Installation

Do not use at temperatures below 35° F (2° C). Maintain NovaLink WM materials above room temperature before applying.

Remove all dirt, oil, loose paint, water, frost and other contamination that can interfere with bonding. Form release residue and lime should be power washed and allowed to dry.

NovaLink WM may be applied to green concrete without out-gassing. Although concrete cure times may vary with temperature, for optimum bonding, concrete cure time should be three to seven days. Application surfaces must be dry the touch and free of obvious moisture.

Repair and level all surface defects, grout lines, joints and penetrations with NovaLink FP. In transition joints, or where damage is excessive, reinforce with Tietex T-326 fabric. In right angle joints use NovaLink FP to form a one inch cant.

This Is A Special Order Item

Find a Rep

Physical Properties

    • fast cure fast setting, moisture cure
    • time savings bonds to green concrete; minimize the wait
    • high solids % wet film equals dry film thickenesses
    • solvent free very low odor
    •